Publicidad
Step 17
Slide the SUPPORT ROD (DD) through the RIGHT UPRIGHT (C).
å
Turn the TURNBUCKLE (FF) several turns onto the LONG SUPPORT
å
ROD (EE). Turn the SUPPORT ROD (DD) into the other end of the
TURNBUCKLE several turns.
NOTE: If the TURNBUCKLE will not turn onto the threads, use the
å
other end of the TURNBUCKLE. Turn the TURNBUCKLE onto the
RODS until the holes in the SUPPORT ROD (DD) line up with the holes
in the TOP (E).
Now, fasten the SUPPORT ROD (DD) to the TOP (E). Use two SILVER
å
9/16" PAN HEAD SCREWS (VV).
Slide a Spacer (from the Return hardware bag) under the LONG
å
SUPPORT ROD (EE)as close to the fastened end as possible.
Hand tighten the TURNBUCKLE until it is snug. Now, use your
å
screwdriver to tighten the TURNBUCKLE another 1/4 turn.
NOTE: Tighten the TURNBUCKLE more if the TOP ever begins to sag.
å
SILVER 9/16" PAN HEAD SCREW
(2 used in this step)
Page 22
VV
FF
C
E
DD
Spacer (from the Return)
404972
Drawers on right side of the desk
EE
www.sauder.com/services
Publicidad
