Publicidad
Step 4
Separate the EXTENSION SLIDES (Y and BB) from the
å
EXTENSION RAILS (X and AA) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (X and AA) to the ENDS (A and B)
å
and UPRIGHTS (C and D2). Use sixteen GOLD 5/16" FLAT
HEAD SCREWS (XX).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of
the EXTENSION RAIL out to fi nd the other hole that lines up with
the hole in the END. Turn a SCREW into this hole.
GOLD 5/16" FLAT HEAD SCREW
(16 used in this step)
AA
Open end
Finished edge
Use the exact holes shown.
www.sauder.com/services
Push the black lever in and pull the SLIDE from the RAIL.
XX
A
C
X
AA
Open end
Open end
Open end
AA
X
AA
D2
B
X
404972
Drawers on both sides of the desk
Open end
Finished edge
X
Page 9
Publicidad
