Publicidad
Step 33
1
D447
I
Groove
Insert the LARGE DRAWER SIDES (D447 and D88) at
å
an angle into the slot at each end of the LARGE RIGHT
DRAWER FRONT (I).
3
Fasten the LARGE DRAWER BACK (D78) to the LARGE
å
DRAWER SIDES (D447 and D88). Use four BLACK 1-9/16"
FLAT HEAD SCREWS (30S).
NOTE: Be sure the LARGE DRAWER BOTTOM (D708)
å
inserts into the groove of the LARGE DRAWER BACK (D78).
Repeat this step for the other drawers.
å
Page 38
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D88
D78
D447
D708
VIEW THE T-LOCK BOX VIDEO
2
D447
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the LARGE DRAWER BOTTOM (D708) into the
å
grooves in the LARGE DRAWER SIDES (D447 and D88)
and LARGE RIGHT DRAWER FRONT (I).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D88
404972
With the palm of
your hand, tap the
DRAWER BOTTOM
down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D708
D88
I
30S
(16 used in this step)
www.sauder.com/services
Publicidad
