Publicidad
Step 27
Turn the TURNBUCKLE (FF) several turns onto the LONG SUPPORT
å
ROD (EE). Turn the SUPPORT ROD (DD) into the other end of the
TURNBUCKLE serveral turns.
NOTE: If the TURNBUCKLE will not turn onto the threads, use the
å
other end of the TURNBUCKLE. Turn the TURNBUCKLE onto the
RODS until the holes in the SUPPORT ROD (DD) line up with the
holes in the TOP (E).
Now, fasten the SUPPORT ROD (DD) to the TOP (E). Use two SILVER
å
9/16" PAN HEAD SCREWS (VV).
Slide a Spacer (from the Return hardware bag) under the LONG
å
SUPPORT ROD as close to the fastened end as possible.
Hand tighten the TURNBUCKLE until it is snug. Now, use your
å
screwdriver to tighten the TURNBUCKLE another 1/4 turn.
NOTE: Tighten the TURNBUCKLE more if the TOP ever begins to sag.
å
Page 32
E
EE
DD
Spacer (from the Return)
VV
SILVER 9/16" PAN HEAD SCREW
(2 used in this step)
404972
Drawers on left side of the desk
FF
www.sauder.com/services
Publicidad
