Sauder 404972 Manual Del Usuario página 27

Step 22
Separate the EXTENSION SLIDES (Y and BB) from the
å
EXTENSION RAILS (X and AA) as shown in the upper
diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (X and AA) to the LEFT
å
END (B) and UPRIGHTS (C and D2). Use twelve GOLD
5/16" FLAT HEAD SCREWS (XX).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL out to fi nd the other
hole that lines up with the hole in the END. Turn a SCREW
into this hole.
This UPRIGHT will
not be used until the
Return is assembled.
Finished edge
Open end
www.sauder.com/services
Push the black lever in and pull the SLIDE from the RAIL.
Use the exact
holes shown.
AA
C
X
AA
Use the exact
holes shown.
Open end
Open end
AA
D2
X
X
B
404972
Drawers on left side of the desk
GOLD 5/16" FLAT HEAD SCREW
(12 used in this step)
Finished edge
XX
Page 27