Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Application Service - Bosch Zamo Manual Original

OBJ_BUCH-2439-002.book Page 23 Wednesday, August 19, 2015 9:07 AM
Checking the Measuring Tool
The accuracy of the measuring tool can be checked as follows:
– Select a permanently unchangeable measuring section with a length of
approx. 3 to 10 metres; its length must be precisely known (e.g. the
width of a room or a door opening). The measurement should be car-
ried out under favourable conditions, meaning, the measuring dis-
tance must be indoors and the target surface for the measurement
must be smooth and reflect well.
– Measure the distance 10 times after another.
Under favourable conditions, the deviation of the individual measure-
ments from the mean value must not exceed ±3.5 mm (max.) over the
complete measuring distance. Log the measurements, so that you can
compare their accuracy at a later point of time.

Maintenance and Service

Maintenance and Cleaning

Keep the measuring tool clean at all times.
Do not immerse the measuring tool in water or other fluids.
Wipe off debris using a moist and soft cloth. Do not use any cleaning
agents or solvents.
Maintain the reception lens 8 in particular, with the same care as required
for eye glasses or the lens of a camera.
For repairs, send in the measuring tool in.

After-sales Service and Application Service

Our after-sales service responds to your questions concerning mainte-
nance and repair of your product as well as spare parts. Exploded views
and information on spare parts can also be found under:
www.bosch-pt.com
Bosch's application service team will gladly answer questions concerning
our products and their accessories.
In all correspondence and spare parts orders, please always include the
10-digit article number given on the nameplate of the product.
Bosch Power Tools
English | 23
2 609 141 294 | (19.8.15)