Troubleshooting; Error Code - GYS EXAGON 400 CC Manual Del Usario

Hot Start
Hot Start
time
AntiSticking
Back to Setup
menu
Frequency
(MMA vertical up)
Perrcentage
(MMA vertical up)

TROUBLESHOOTING

This device integrates a default management system. In the event of a default, error messages may be displayed.

Error code

+
+
+
+
à
+
ou
All operations requiring the removal of the machine's cover and checking the electrical systems must be done by a qualified technician.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
EXAGON 400 CC/CV
Current
value
Current
value
Current
value
Current
value
Current
value
Signification
Duty cycle excessed.
Thermal protection Ambient temprature above 40°C.
Obstructed air input.
Mains power is out of range or one phase
Mains voltage default.
is missing.
Current sensor default The current sensor is inactive or faulty.
Power relay command
The power relay could not be closed.
default.
No temperature informa-
The temperature sensor is off.
tion.
One of the fans is not rotating at the right
Fan default.
speed.
...
...
...
...
...
1s
CAUSES
Wait for the indicator to turn off before resuming
welding operations.
Oserve the duty cycle and insure a good ventilation.
Using the optional anti dust filter will reduce the duty
cycle.
Have your electrical installation checked by a quali-
fied person. The voltage between the phases must be
between 340V RMS and 460V RMS.
Have the sensor's connection cables checked by a
qualified person.
Have the relay's command connection cables checked
by a qualified person.
Have the sensors' connection cables checked by a
qualified person.
Check that there is no foreign object obstructing the
fan, check the cabling , replace the fan.
EN
Validate current
setting
1s 1s
Reset current
setting
SOLUTIONS
23