Ryobi LLCDI1802 Manual De Utilización página 8

EN
FR DE ES IT
OPERATION
NOTE: The drill will not run unless the rotation selector is
pushed fully to the left or right.
Avoid running the drill at low speeds for extended periods
of time. Running at low speeds under constant usage
may cause the dr ill to become
cool the drill by running it without a load and at full speed.
INTERNAL SPINDLE LOCK
The internal spindle lock allows
control of chuck adjustments and bit changes . Squeezing
the chuck body stops the chuc
bit changes and chuc k adjustments , squeez e the chuc k
body and turn.
KEYLESS CHUCK
See Figure 4.
The drill has a keyless chuc k to tighten or release drill
bits in the chuck jaws. The arrows on the chuc k indicate
which direction to rotate the chuck body in order to LOCK
(tighten) or UNLOCK (release) the drill bit.
WARNING
Do not hold the chuck with one hand and use the
power of the drill to tighten the chuck jaws on the
drill bit. The chuck body could slip in y
or your hand could slip and come in contact with
the rotating drill bit. This could cause an accident
resulting in serious personal injury.
TWO-SPEED GEAR TRAIN (HI-LO)
See Figure 5.
The dr ill has a two-speed
or driving at LO (1) or HI (2 ) speeds . A slide s
1. APPLICATION
• Lag screws up to 9.5 mm dia. by 38.1 mm long
• Hole saw up to 50.8 mm
• Spade bits up to 38.1 mm
• Drill bits up to 12.7 mm
• Drilling into metal
• Concrete screws
• Drill bits up to 6.4 mm
• Deck or wood screws up to 76.2 mm long
• Self tapping screws
• Deck or wood screws up to 76.2 mm long
• Small screws or delicate work that requires more control
• Masonry bit up to 12.7 mm
NL PT DA SV FI NO
overheated. If this occurs ,
the user single-handed
k ja ws from tur ning. For
our hand,
gear train designed for dr illing
witch is
RU PL CS HU RO
English
located on top of the dr
speed. When using drill in the LO (1) speed range, speed
will decrease and unit will ha
When using dr ill in the HI (2) speed range, speed will
increase and unit will ha
LO (1) speed for high power and torque applications and
HI (2) speed for fast drilling or driving applications.
CAUTION:
Never change gears while the tool is r
Failure to obey this caution could result in serious
damage to the drill.
QUICK MODE SELECTOR
See Figure 6.
The Quic k Mode Selector allows y ou to quickly switch
from drill mode to drive mode.
In general, drill mode should be used f
other heavy duty applications
used for driving screws
for impact drilling.
SELECTING DRIVE OR DRILL SETTING
See Figure 5-6.
Using the char t belo w, choose correct speed and mode
the type of bit, fastener, and material you will be using.
■
Choose your APPLICATION
■
Choose the correct SPEED: (1/LOW or 2/HIGH)
■
Choose the correct MODE: (DRIVE, DRILL, OR
HAMMER)
2. SPEED
1/LOW
(TORQUE ADJUSMENT NOT ACTIVE)
2/HIGH
1/LOW
2/HIGH
1/LOW
(TORQUE ADJUSMENT NOT ACTIVE)
2/HIGH
3
LV LT ET HR SL SK
ill to select either LO (1) or HI (2)
ve more power and torque .
ve less power and torque . Use
unning.
or dr illing and
. Drive mode should be
. Hammer mode should be used
3. MODE
DRILL MODE
DRIVE MODE
HAMMER MODE
EL TR