Lenze L-force 9400 Serie Instrucciones Para El Montaje página 72

8 Wiring the device modules
Memory modules
S220
Fig. 8−6
Via the DIP switches on the front, you can set:
the node address (labelling "1" ... "64") and
ƒ
baud rate (labelling "a" ... "d")
ƒ
)
Note!
If DIP switches 1 ... 64 = OFF ("Lenze setting"): When the standard device is
switched on, the parameterisation of codes C00350 (node address) and
C00351 (baud rate) is activated.
Switch the voltage supply of the standard device off and then on again to
activate altered settings.
Setting the node address
The node address of the drive is calculated from the sum of all address switches in the "ON"
position.
Setting the baud rate
d c
OFF ON
OFF ON
OFF OFF
OFF OFF
OFF OFF
OFF OFF
ON ON
OFF ON
OFF ON
72
O
N
d c b a 64 32 16 8 4
Baud CAN Address
Arrangement and labelling of the DIP switches
b a Baud rate
ON OFF 10 kbps
OFF ON 20 kbps
ON ON 50 kbps
ON OFF 125 kbps
OFF ON 250 kbps
OFF OFF 500 kbps
ON OFF 800 kbps
OFF OFF 1000 kbps
ON ON Automated recognition
l
2 1
9400CAN003
EDK94ARN24 DE/EN/FR/ES/IT 3.0