Preventing Material Damage; Leakage And Pipe Breakage; Dry Running; Cavitation - Speck Normblock Multi Serie Traducción De Las Instrucciones Para El Manejo Originales

Pos: 63 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Vermeidung von Schäden/Vermeidung von Sachschäden @ 0\mod_1427787266105_370.docx @ 26782 @ 2 @ 1
2.9

Preventing material damage

Pos: 64 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Vermeidung von Schäden/Undichtigkeit und Rohrleitungsbruch Multi @ 5\mod_1450348673215_370.docx @ 59483 @ 3 @ 1
2.9.1

Leakage and pipe breakage

Vibrations and thermal expansion can cause pipes to break.
 Install the pump/unit in a manner which reduces structure-
borne and airborne noise transmission. When doing so,
observe relevant regulations.
If the pipe forces are exceeded, leaks can occur at the screwed
connection or the pump itself.
 Do not use the pump as a fixed point for the pipe line.
Connect pipes free of load and mount them elastically. Install

compensators.
 If the pump leaks, the unit may not be operated and must be
disconnected from the mains power supply.
Pos: 65 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Vermeidung von Schäden/Trockenlauf @ 0\mod_1427789053644_370.docx @ 26812 @ 3 @ 1
2.9.2

Dry running

If run dry, mechanical seals and synthetic parts can be destroyed
within only a few seconds.
 Do not allow the pump to run dry. This also applies to
checking the rotation direction.
 Purge air from pump and suction line prior to start-up.
Pos: 67 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Vermeidung von Schäden/Kavitation @ 0\mod_1427790036391_370.docx @ 26832 @ 3 @ 1
2.9.3

Cavitation

Pipes which are too long increase resistance. This results in risk
of cavitation.
 Ensure that the suction line does not leak.
 Observe the maximum pipe length.
 Only switch the pump on when the valve on the delivery side
is opened halfway.
 Open the valve on the suction side completely.
Pos: 69 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Vermeidung von Schäden/Überhitzen Multi @ 5\mod_1450348093615_370.docx @ 59465 @ 3 @ 1
2.9.4

Overheating

The following factors can result in the pump overheating:
• Excessive pressure on the delivery side.
• Motor overload switch set incorrectly.
• Ambient temperature which is too high.
 Do not operate the pump with the valves closed, minimum
flow rate 10 % of Qmax.
04/2016
Safety
EN 13