Using The Remote Control - Aerian AAC9K Manual Del Usuario

Remote control display
USING THE REMOTE CONTROL
Installing batteries
1. Remove the battery cover.
2. Insert two supplied batteries in the compartment,
making sure the + and – polarities are correctly
aligned.
3. Reinstall the battery cover.
NOTE: If you will not use the appliance for a long time, remove the batteries from the remote control.
How to use the remote control
Point the remote control toward the signal receiver window of the appliance and then press the desired
button on the remote control. The appliance will generate a beep when it receives the signal.
• Make sure there is no curtain or other object between the remote control and the appliance.
• The remote control can send signals from up to 7 meters away.
CAUTION:
• Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its
operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light.
• Using a fluorescent lamp with a quick starter in the same room may
interfere with transmission of the signal.
• Do not leave the remote control in direct sunlight or near a heater. Also,
protect the appliance and remote control from moisture and shock
which can discolour or damage them.
EN-8
Install
Remove