Drainage - Aerian AAC9K Manual Del Usuario

DRAINAGE
Under high humidity conditions it may be necessary to empty the internal water tank. When the internal
water tank is full the display will show "H8".
The cooling/dehumidification process will stop.
Before the appliance is turned on, you can insert the rubber plug to the bottom drainage point or attach
the supplied drain hose to the continuous drainage point.
To attach the supplied drain hose to the bottom drainage point:
1. Remove the rubber plug from the bottom drainage point.
2. Fix the bracket on the lower air inlet grille with the supplied screw.
3. Screw one end of the drain hose over the bottom drainage point and then clip it with the hose clamp.
4. Fix the drain hose in the bracket. Clip it with the hose clamp and attach the rubber plug to the other end
of the drain hose.
EN-16