Aerian AAC9K Manual Del Usuario página 20

To empty the water tank do the following:
1. Switch off the appliance and remove the plug from the mains socket.
2. Place a water tray on the floor underneath the bottom drainage point.
3. Remove the rubber plug from the drain and let the water run out.
• If a drain hose is used, do the following:
1) Remove the drain hose from the bracket.
2) Remove the rubber plug from one end of the hose.
3) Put the drain hose onto the water tray.
4. Replace the rubber plug or drain hose, plug the appliance into the mains socket, and switch the
appliance on.
Continuous drainage
When you need operating this appliance in high humidity, during the dehumidification or cooling mode,
connect the drain hose to the continuous drainage point.
1. Remove the drain cap and then remove the rubber stopper from the continuous drainage point.
2. Screw the supplied drain connector on the continuous drainage point.
EN-17