You can remedy minor faults using the following overview.
If in any doubt, please contact your authorised Customer Service.
DANGER
Risk of accidents and injuries due to unintentional move-
ment of the device
Switch off the device before carrying out any care and mainte-
nance work, and remove the ignition key.
Malfunction
Device not running
Dust when sweeping / insuffi-
cient suction power
Sweeping performance not sat-
isfactory
Activation of roller brush / side
brush not working
The roller brush / side brush are
not running
Note
Device performance data
Travel speed
Recommended sweeping speed
Climbing ability (max.)
Turning circle
Working width without side brushes
Working width with 1 side brush
Working width with 2 side brush
Surface performance without side brushes
Surface performance with 1 side brush
Surface performance with 2 side brushes
Mean power input
Protection class
Battery
Battery type
Battery capacity
Battery voltage
Charger
Mains voltage
Power frequency
Protection class
Dimensions and weights
Length x width x height
Net weight (transport weight)
Troubleshooting guide
Remedy
Charge the battery.
Check/replace the fuse protection on the battery terminal.
Sit in the driver's seat (seat contact switch).
Ignition key to position 1.
Check the position of the neutral lever.
Check the connected battery terminals.
Check the battery plug connector.
Empty the waste container.
Switch on the roller brush or suction fan.
Check / replace the seals.
Check / clean / replace the dust filter.
a Check that the dust filter is firmly in place.
b In case of light soiling, clean the dust filter.
c In case of damage or heavy soiling, replace the dust filter.
Check the sealing strips for wear / set / replace them.
Close the wet sweeping flap.
Reduce the speed of the side brush.
Completely raise the side brush.
Check the roller brush and side brush for wear, replace them as necessary.
Check the sealing strips for wear, replace them as necessary.
Check that the coarse dirt flap is fully functional.
Check that the roller brush is correctly in place.
The side brush only runs if the roller brush is switched on > lower the roller brush.
Contact Customer Service.
Check the roller brush / side brush for any tangled pieces of tape.
Have the micro switch checked by Customer Service.
Technical data
Disconnect the central battery plug connector.
DANGER
Risk of electric shock
Disconnect the central battery plug connector when working on
electrical components.
Repair work and work on electrical components must only be per-
formed by your authorised Customer Service.
In case of all malfunctions not listed, contact Customer Service!
KM 85/50 R Bp
km/h
6
km/h
4
%
12 (max. 3 minutes)
m
2.5
mm
615
mm
850
mm
1085
2
m
/h
3690
2
m
/h
5100
2
m
/h
6510
W
1000
IPX3
---
Ah
---
V
24
V
---
Hz
---
---
mm
1350x940x1170
kg
180
English
KM 85/50 R Bp Pack
6
4
12 (max. 3 minutes)
2.5
615
850
1085
3690
5100
6510
1000
IPX3
Maintenance-free
105
2x12 =24
230
50/60
II
1350x940x1170
230
25