Before You Begin; Avant De Commencer - Kohler K-2553 Guía De Instalación Y Cuidado

Tocador de montaje en la pared
Tabla de contenido

Publicidad

Tools/Outils/Herramientas
2x10
2x6
Siliconized Acrylic Caulk
Mastic à l'acrylique siliconée
Sellador acrílico siliconado

Before You Begin

WARNING: Risk of property damage. Do not modify the vanity in any way.
Doing so will compromise the structural stability of the vanity and may cause
property damage.
WARNING: Risk of property damage. Select 250 lb (113.4 kg) load bearing 5/16"
lag bolts with a length that can safely clear any obstacles in the wall and 5/16"
diameter washers. Calculate the proper length of the lag bolts by adding the
following: 1-1/2" (3.8 cm) backing material + wall board thickness + bracket
thickness.
WARNING: Risk of property damage. Select #8 screws with washers that will
penetrate a minimum of 1-1/2" (3.8 cm) into the backing material.
NOTICE: The plumbing must be roughed into the plumbing cutout area of the
vanity. Refer to the lavatory roughing-in and the vanity roughing-in for proper
placement. The water supply and drain lines must be installed before installing the
vanity.
NOTICE: Siliconized acrylic caulk must be used to secure the lavatory to the vanity.
Do not use 100% silicone sealant, which will damage the finish of the vanity.
NOTE: Plumbing fittings will be exposed and visible once the vanity installation is
complete. Plated plumbing fittings are recommended.
NOTE: The dimensions provided in this Installation and Care Guide will result in a
34-1/2" (87.6 cm) vanity height with lavatory. If an alternate height is desired, use the
rough-in provided with the vanity and lavatory to determine the proper height of the
backing material and hanger brackets.
Observe all local plumbing and building codes.
Two people should install this product.
Kohler Co. reserves the right to make revisions in the design of products without
notice, as specified in the Price Book.

Avant de commencer

AVERTISSEMENT: Risque d'endommagement du matériel. Ne pas modifier le
meuble de quelque manière que ce soit. Ceci compromettrait la stabilité du
meuble de toilette et pourrait causer des dommages matériels.
Kohler Co.
Plus/Plus/Más:
• 5/16" Lag Bolts (4)
Tire-fond (4)
Pernos de fijación (4)
• Flat Washers 5/16" ID (2)
Rondelles plates Ø 5/16" Int. (2)
Arandelas planas de 5/16" D.E. (2)
• Framing Nails
Clous de cadrage
Clavos para estructuras de madera
• #8-Finishing Screws and Washers (4)
Clous de finition (4)
Clavos de tornillos (4)
• Wood Shims (optional)
Cales en bois (optionnel)
Cuñas de madera (opcional)
3
1110179-2-A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-2556

Tabla de contenido