Shark V2930 Guia Del Usuario página 11

CHARGING YOUR CORDLESS FLOOR AND CARPET SWEEPER
Fig. 3
1 Always make sure that the unit
is turned off. (Fig. 3)
2 Insert the charger plug into the
hole on the back of the unit.
Plug the charger into a wall
outlet. The light next to the
power button will illuminate
when the unit is charging. If the
unit is plugged in and the light is
not illuminated, press the power
button once. The light should
now be illuminated indicating
that the unit is charging. (Fig. 4)
Once the charge is completed,
the light will go off.
USING YOUR CORDLESS FLOOR AND CARPET SWEEPER
1 Press the power button to
start the unit. When finished
cleaning, press the power
button again to turn the unit off.
(Fig. 5)
2 To clean under furniture, use
the Shark Backsaver
®
handle. Press the handle
OFF
3 Charge the battery for 7 hours
before initial use and 7 hours
for each recharge. Your cordless
floor and carpet sweeper is
powered by NIi-MH batteries
that need this time to build up
their charge.
4 For best battery performance,
remove the charging adapter
from the unit after the charging
period has completed. Storing
the unit with the adapter
attached and plugged in will
reduce the battery life.
Fig. 5
release button and apply a bit
of pressure to bend the handle
forward. (Fig. 6) The Shark
Backsaver
from the locked position to
reach messes under furniture.
(Fig. 7)
folding
™
Fig. 4
Fig. 6
®
joint will release
™
IMPORTANT: Although many
adaptors look similar, it's
important to use only the
adaptor that came with the unit
(XA2700).
3 Do not use the unit to pick up
liquids or clean wet floors.
4 Do not use the unit on concrete,
tar or other rough surfaces.
5 Do not use the unit to pick
up pieces of string or fabrics.
Do not use the unit to clean
tasseled or frayed carpets.
www.sharkclean.com
Fig. 7
11