Peavey Bandit 112 Manual Del Usuario página 14

POWER AMPLIFIER SECTION:
Rated Power and Load:
Power specs measured with T-Dynamics @ 100%
80W RMS into 8 Ohms
100W RMS into 4 Ohms
Power @ Clipping: (Typically)
(5% THD, 1 kHz, 120V AC line)
80W RMS into 8 Ohms
100W RMS into 4 Ohms
Frequency Response:
+0, -3 dB 100 Hz to 20 kHz @ 65W RMS
into 8 Ohms
Hum and Noise:
Greater than 88 dB below rated power
Power Consumption:
300W @ 60 Hz, 120V AC, Domestic
300W @ 50/60 Hz, 220-230/240V AC, Export
PREAMP SECTION:
The following specs are measured @ 1 kHz with the
controls preset as follows:
Channel Select, Clean
Clean Mode Switch, Modern
Low and High @ 10
Mid @ 0
Lead Pre and Post Gain @ 10
Lead Mode Switch, Vintage
Reverb @ 0
Nominal Levels are with Clean Volume @ 5
Minimum Levels are with Clean Volume @ 10
Preamp High Gain Input:
Impedance: High Z, 250 K Ohms
Nominal Input Level: -14 dBV, 185mV RMS
Minimum Input Level: -23 dBV, 66mV RMS
Maximum Input Level: +0 dBV, 1V RMS
Preamp Low Gain Input:
Impedance: High Z, 44 k Ohms
Nominal Input Level: -8 dBV, 380 mV RMS
Minimum Input Level: -17 dBV, 136 mV RMS
Maximum Input Level: +6 dBV, 2 V RMS
Specifications subject to change without notice.
BANDIT ® 112
SPECIFICATIONS
Effects Send:
Load Impedance: 1 k Ohms or greater
Nominal Output Level:
Effects Level switch "out": -10 dBV,
0.32V RMS
Effects Level switch "in": 0 dBV, 1V RMS
Effects Return:
Impedance: High Z, 22k Ohms
Designed Input Level:
Effects Level switch "out": -10 dBV,
Effects Level switch "in": 0dBV, 1V RMS
(Switching jack provides Effects Send to Effects
Return connection when not used.)
Preamp Output:
Load Impedance: 1 k Ohms or greater
Nominal Output Level: 0 dBV, 1V RMS
Power Amp Input:
Impedance: High Z, 22k Ohms
Designed Input Level: 0 dBV, 1V RMS
(Switching jack provides preamp output to power
amp input connection when not used.)
System Hum and Noise @ Nominal Input Level:
(20 Hz to 20 kHz unweighted)
Greater than 78 dB below rated power
Equalization:
Special Low, Mid, and High passive type EQ
Modern/Vintage switch (Clean): Two distinct
Vintage/Modern/High Gain switch (Lead):
Three different EQ and Gain voicings
Presence: +6 dB @ 5 kHz
Push Resonance: +6 dB @ resonant
External Footswitch Functions:
Select: Clean or Lead channel selection
Effects: Effects loop bypass
Dimensions (H x W x D):
19.75" x 23.63" x 11.5"
50.16cm x 60.02cm x 29.2cm
Weight:
43.9lbs. (19.91kg)
14
0.32V RMS
EQ voicings
frequency of cabinet