Mounting The Kombitool; Starting / Stopping The Engine - Stihl BG-KM Manual De Instrucciones

Mounting the KombiTool

2
1
4
3
Mounting
: Engage lug (1) on drive tube in
slot (2) in the coupling sleeve and
push home the drive tube as far as
stop.
: When correctly installed, the small
gap between the intake screen (3)
and the coupling sleeve must be no
more than 5 mm.
: Tighten the wing screw (4) firmly.
Removing
: Reverse the above sequence to
remove the drive tube.
BG-KM
Starting / Stopping
the Engine
Starting the Engine
Always follow the starting procedure
outlined in the instruction manual of the
basic power tool or KombiEngine you
are using.
Start the engine on a clean, dust-
free surface so that the unit does not
ingest dust.
: Place the unit on the ground – make
sure bystanders are well clear of the
nozzle outlet.
English / USA
: Make sure you have a firm footing.
: Press the unit firmly against the
ground with your left hand.
Do not stand or kneel on the drive
tube!
The starting procedure is now as
described in the instruction manual of
the basic power tool or KombiEngine
you are using.
Stopping the Engine
: Move the slide control in direction of
arrow ( h ) to STOP-O or move the
stop switch to O.
11