dirna Bergstrom bycool FLAT Instrucciones De Montage página 20

FLAT
ES
EN
ASSEMBLY RECOMMENDATIONS
• Before starting assembly, please read instruc-
tions and follow them during installation process.
• Use the adequate tools for each operation.
ELECTRICITY
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely
connected, checking their correct fitting.
WARNING:
When installing the evaporative unit in the
ceiling, protect the upper part of the cabin with
a cloth or sheet to prevent scratching. When
installing Bycool Flat in the ceiling, bear in mind
that cabins are normally fitted with a hatch and
have a structure which can withstand the weight
of the unit. However, if this is not so and it is
necessary to open up the ceiling, or should the
hatch material not be sufficiently resistant (e.g.
fibre, plastic, etc) the installer must decide, under
his sole responsibility, on the need to reinforce
the ceiling in order to prevent deformation,
breakage, incoming water, etc, and use the means
necessary to this end.
Torx wrenches set
Allen wrenches set
Open-jawed spanner 10
Open-jawed spanner 13
Open-jawed spanner 14
Scissors
Flexo-meter
DOCUMENTATION INCLUDED WITH
EQUIPMENT:
• Mounting instructions: 220.AA7.0009
• User's guide: 220.AA7.0013
• Troubleshooting: 220.AA7.0004
• Warranty: 220.AA1.0010
WARNINGS:
Piece 17 of the listing of provided pieces must be
replaced every 12 months
dirna Bergstrom, s.l.
•
for breakdowns or damages coming from an
inadequate handling or installation of the equipment
or from modifications and substitutions carried out
without our express and written authorisation.
• Please see product warranty procedure included
in Troubleshooting diagnosis.
• Please see equipment User's Guide for its correct
functioning of the remote control and control panel.
20
Tools
shall not be responsible
®