dirna Bergstrom bycool FLAT Instrucciones De Montage página 27

FLAT
Place console and centre equipment in the most
11
convenient place of cabin roof. Once centred,
remove console for later installation.
Fasten supports tightening nuts until outside
12
EPDM joint of equipment is compressed, bet-
ween 3 and 6 mm; the meeting must be with a
thickness between 19 and 22 mm
Important: To avoid water from filtering in-
side cabin, check EPDM joint tightening with
Minicool base, as indicated on diagram.
3-6mm.
Cabin roof
Fasten selflocked nut until
EPDM gasket is compressed
12
between 3 and 6 mm.
Tighten (4) M8 nuts to support and (4) to Unit
13
base.
EPDM gasket
10 mm*
(*) (approx. after tightening)
Base
Support
13
27
11
Check compression
thickness using a tape
measure in the four
corners.
EPDM gasket
ES
EN
®
12