Peavey Ecoustic Serie Manual Del Usuario página 6

A A u u x x i i l l i i a a r r y y C C h h a a n n n n e e l l L L o o w w ( ( 4 4 ) )
This is an active‚ shelving type EQ for increasing the low end on the auxiliary input channel.
A A u u x x i i l l i i a a r r y y C C h h a a n n n n e e l l H H i i g g h h ( ( 5 5 ) )
An active‚ shelving type EQ for dialing in the highs on the auxiliary input channel.
I I n n p p u u t t ( ( 6 6 ) )
This 1/4" mono jack is designed to accommodate most any signal input. Gain can be adjusted by the
Auxiliary Input Level (7).
A A u u x x i i l l i i a a r r y y I I n n p p u u t t L L e e v v e e l l ( ( 7 7 ) )
This control sets the overall level of the auxiliary channel.
M M i i c c r r o o p p h h o o n n e e C C h h a a n n n n e e l l R R E E V V / / D D L L Y Y ( ( 8 8 & & 2 2 1 1 ) )
The Ecoustic 112 and the Ecoustic 110 include separate effects for the Mic channel and the Instrument
channel. These controls set the amount and mix of delay/reverb and when depressed‚ turns on and off the
chorus for the Mic channel. See the Tweak Section of this manual for more information and hidden features.
I I n n s s t t r r u u m m e e n n t t C C h h a a n n n n e e l l R R E E V V / / D D L L Y Y ( ( 9 9 & & 2 2 2 2 ) )
This control sets the amount and mix of delay/reverb effects for the Instrument channel. As the control is
turned clockwise‚ the surrounding LED ring will light‚ indicating the amount and/or mix of reverb and delay.
When turned fully counter-clockwise‚ the reverb/delay effects are off.
E E F F X X A A d d j j u u s s t t ( ( 1 1 0 0 & & 2 2 3 3 ) )
Repeatedly depressing this control cycles through the available effects: Doubler‚ Phaser‚ Chorus and
Rotary Speaker. The LED adjacent to each effect name will light indicating which effect is active. Rotating
this same control will change various parameters for each effect. The surrounding LED ring will also
illuminate indicating relative value of the parameter being adjusted. The effects and their corresponding
parameters are listed on the next page.
As the knob is turned clockwise‚ the
surrounding LED ring will light‚ indicating the
amount and/or mix of reverb and delay. When
turned fully counter-clockwise‚ the reverb/delay
effects are off.
When the knob is pushed in‚ the Chorus LED
will light‚ indicating the chorus effects are
engaged.
6