Publicidad
Step 7
Step
Separate the EXTENSION SLIDES (Z) from the EXTENSION
å
RAILS (Y) as shown in the upper diagram below. Be prepared,
the parts are greasy.
Fasten the EXTENSION RAILS (Y) to the DRAWER ENDS (C
å
and D). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge
of the EXTENSION RAIL in to fi nd the other hole that lines up
with the hole in the END. Turn a SCREW into this hole.
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Q
Open end
Page 12
Z
Push the black lever in and pull the SLIDE from the RAIL.
3S
D
Y
R
C
416969
Y
Y
www.sauder.com/services
Open end
Publicidad
