Sauder 416969 Manual De Instrucciones página 19

Step Step 14
Lay the BACKS (M and N) over the assembled units.
å
NOTE: The BACK (N) has an unfi nished surface. This BACK
å
should be placed on the DRAWER ENDS (C and D) with the
unfi nished surface toward the inside of the unit.
Make equal margins along all four edges of the BACKS (M
å
and N). Push on opposite corners of your units if needed to
make them "square".
Fasten the BACKS (M and N) to the units using the NAILS (1N).
å
NOTE: Perforations have been provided for access through the
å
BACKS. Carefully cut out the holes needed.
A
www.sauder.com/services
Edge without holes
M
B
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(38 used in this step)
C
416969
1N
Edge without holes
N
D
Page 19