Sauder 416969 Manual De Instrucciones página 29

Step Step 24
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (O) to the DOOR LEFT END (B). Use the
å
screws in the HINGES. You should start each SCREW a
few turns before completely tightening any of them.
See the next step for DOOR adjustments.
å
Fasten a KNOB SET (52K) to the DOOR (O). Use a
å
BLACK 1-1/8" MACHINE SCREW (21S).
Insert the DOOR STOP (4I) into the hole in the TOP (H).
å
52K
BLACK 1-1/8" MACHINE SCREW
(1 used for the KNOB SET)
www.sauder.com/services
B
O
4I
21S
H
416969
Stop
Mounting
screw
Hinge
Page 29