Front Panel - Peavey Triple XXX 40/EFX Manual Del Usuario

FRONT PANEL

®
Triple XXX 40
1 2 3
9 10 11
(1) INPUT
This 1/4" jack is designed to accommodate most any guitar output signal. Input signal gain can be adjusted by the
GAIN controls on both the Ultra and Rhythm channels.
(2) Ultra Channel—Activation LED
This indicator illuminates when the Ultra channel is selected. Channel changing can also be accomplished by the 2-
position toggle switch (19) or the included footswitch. Each model comes with a different footswitch. Please read
the Footswitch section in this manual for operation.
(3 & 11) GAIN
This control, on both channels, controls the input volume level of the respective channel. Rotating this control
clockwise will increase the amount of preamp distortion and sustain.
(4 & 12) VOLUME
This control, on both channels, sets the overall level of the respective channel.
(5) BOTTOM
This control‚ on the Ultra channel, varies the low frequency response of the amplifier. It is an active control (shelving
type) and allows 15 dB of boost or cut.
(6) BODY
This control, on the Ultra channel, varies the mid frequency response of the amplifier. It is an active control
(peak/notch type) and allows 15 dB of boost or cut.
(7) EDGE
This control, on the Ultra channel, varies the high frequency response of the amplifier. It is an active control
(shelving type) and allows 15 dB of boost or cut.
(8 & 16) Reverb
This control sets the reverb level per channel. It works the same for both channels. (Note to Triple XXX 40 EFX
owners: These controls are completely separate from the Digital Effects. Changing this control only affects the built-
in spring reverb.)
4 5 6 7
12 13 14 15
8 17 19
16 18
5
21
20 22