Before Initial Use; Boiling Water - Beem CLASSIC SELECTION POUR OVER Guía De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN

Before Initial Use

1. To remove possible production residues, fi ll the kettle
before you fi rst use it with approx. 1000 ml of drinking
water and allow it to boil (see the "Boiling Water" chapter).
2. Pour this water away. You must not drink it under any
circumstances!
3. Repeat this process twice.
4. Clean the kettle and the lid by following the instructions in
the "Cleaning and Care" chapter.
Your kettle is now ready to be used!

Boiling Water

Bear in mind that induction stoves heat up at a faster
rate than other types of stove. Noises may also be
produced when the product is used on induction stoves.
These are caused by the electromagnetic properties
of induction stoves and induction crockery and do not
constitute a defect.
1. Take the lid off the kettle.
2. Fill the kettle with the amount of drinking water you want.
Make sure you do not fi ll the kettle right up to the brim
as the water might escape from the pouring spout during
boiling.
3. Place the lid back on the kettle.
20

Publicidad

Tabla de contenido
loading

Tabla de contenido