Section 6. Menu Flow Chart - Zodiac JEP-R Manual De Instalación Y Operación

Page 18
ENGLISH

Section 6. Menu Flow Chart

[OFF]
[1, 3]
SET SPEED
[2750 RPM]
[1, 3]
2
USE
[1, 4]
3 4
MENU
NOTES
Default parameters are shown in [ ].
1. Accessed directly by front panel button.
2. Occurs at Run Screen.
3. Timeclock features accessed via MENU button while
eStar or speed 2 is running.
4. MENU button has no effect when running.
5. Accessed via MENU button when pump is stopped.
6. Press and hold MENU button for five (5) seconds to enter
User Setup menu.
7. Is not affected when "LOAD DEFAULTS" is executed.
8. Key that is pressed to wake up display is also acted
upon.
9. Press and hold MENU first, then eStar and 4, and hold all
three for five (5) seconds to enter Service Setup menu.
10. Setting not saved in non-volatile memory; reset to "NO"
after execution.
11. Minimum operating speed is 1050 RPM for Jandy Pro
Series SVRS-equipped pumps.
12. Minimum priming speed is 1500 RPM for Jandy Pro Series
SVRS-equipped pumps.
ePump™ and VS-FloPro™ Variable-Speed Pump Controller
TIMECLOCK
MENU MENU
MENU
MENU
SET ON TIME
[12:00 AM]
SET OFF TIME
[8:00 AM]
TIMECLOCK
MENU MENU
MENU MENU
SET ON TIME
[12:00 AM]
SET OFF TIME
[8:00 AM]
SET SPEED
[2750 RPM]
[5]
SET SPEED
SPEED 5-8
MENU
[2750 RPM]
|
[DISABLE]
ENABLE
NOTES
Default parameters are shown in [ ].
1. Accessed directly by front panel button.
2. Occurs at Run Screen.
3. Timeclock features accessed via MENU button while
eStar or speed 2 is running.
[DISABLE]
4. MENU button has no effect when running.
5. Accessed via MENU button when pump is stopped.
6. Press and hold MENU button for five (5) seconds to enter
ENABLE
User Setup menu.
7. Is not affected when "LOAD DEFAULTS" is executed.
8. Key that is pressed to wake up display is also acted
upon.
9. Press and hold MENU first, then eStar and 4, and hold all
three for five (5) seconds to enter Service Setup menu.
10. Setting not saved in non-volatile memory; reset to "NO"
after execution.
11. Minimum operating speed is 1050 RPM for Jandy Pro
Series SVRS-equipped pumps.
12. Minimum priming speed is 1500 RPM for Jandy Pro Series
SVRS-equipped pumps.
SET SPEED
3 4
[2750 RPM]
Installation Manual
SPEED 5-8
MENU
[5]
MENU