Section 2. Installation Of The Controller; Introduction; The Controller Panel; The Controller Components - Zodiac JEP-R Manual De Instalación Y Operación

ePump™ and VS-FloPro™ Variable-Speed Pump Controller
Listed/Certified to latest
published edition of
ANSI
or its successor stan-
dard, ANSI/APSP-16
Cover/Grate or Suction
Fitting, Screw-fastened
to Main Drain Sump
Suction Outlet
(Main Drain)
WARNING: Suction check valves and hydrostatic valves should not be used with this pump.
Figure 1. Number of Suction Outlets Per Pump
Section 2. Installation of the Digital
Controller
2.1

Introduction

This document provides general instructions to install and
operate the JEP-R Variable-Speed Digital Controller. The
controller can be mounted to an electrical gang box (single,
double, or triple) or to a flat wall.
The instructions have been written with safety as the priority,
and must be followed exactly. Read through the instructions
completely before starting the procedure.
2.2

The Controller Panel

The controller panel provides both timed and manual speed
controls for the ePump and VS FloPro Variable Speed Pumps.
Four (4) speeds are directly available on the panel,
while four (4) additional speeds may be accessed via the
MENU key.
The up and down keys are used to adjust the pump speed. The
speed is saved as it is adjusted. No further action is required
to save the new speed setting after adjustment. The selected
speed can be saved and assigned to one of the speed buttons.
As shown in Figure 1, preset speed "
the "eStar" feature. Hence, it is intended to be assigned
an energy-efficient filtration speed, as determined by the
installer.
/ASME A112.19.8
® ®
Anti-entrapment
Valves OK between
Pump and Tee

" is assigned to
|
Installation Manual
At Least
3 Feet
Listed/Certified to latest
ANSI/ASME A112.19.8
Cover/Grate or Suction
Fitting, Screw-fastened
No Valves between
Tee and Main Drains
2.3

The Controller Components

The controller assembly (See Figure 3) contains the following
components:
1. Controller
2. Mounting Gasket
3. Backplate
4. Round Seal
5. Six (6) Screws
6. Plastic Film
LED Lights
eStar Button
Figure 2. JEP-R Variable Speed Pump Controller
Panel
Additional materials are required for the installation of the
controller and must be supplied by the installer:
1. A cable to connect the pump to the remotely mounted
controller, minimum size of 22 AWG (Jandy part number
4278). This cable will need to have four (4) conductors
and be able to handle 24V control signals. This cable
should be rated for the particular installation (for
example: outdoor, UV resistant, direct burial, etc.) and
ENGLISH
published edition of
or its successor stan-
dard, ANSI/APSP-16
Anti-entrapment
to Main Drain Sump
Suction Outlet
(Main Drain)
Pump
LCD Display
Arrow Keys
PRESS SPEED OR MENU
12:00AM PUMP IS OFF
2 3 4
MENU
Menu Button
Preset Speed
Page 7
Up/Down
Buttons