Installing The Ups - Eaton Powerware 9125 Guia De Instalacion

Installing the UPS

NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur to
your equipment and void your warranty.
Figure 10 shows a typical installation only. See "UPS Rear Panels" on
page 10 for the rear panel of each model.
To install the UPS and optional EBMs:
1.
2.
3.
UPS Battery
Connector
EBM Cable
®
EATON Powerware 9125 (9910-P10, P11, P15, P16) UPS Installation Guide for IBM
If installing an optional EBM, continue to Step 2; otherwise, skip to
Step 4.
Plug the EBM cable of the first EBM into the UPS battery connector
(see Figure 10).
If additional EBMs are to be installed, plug the EBM cable of the
second cabinet into the battery connector on the first EBM. Repeat
for each additional EBM. Up to four EBMs may be connected to the
UPS.
Relay Interface Card
UPS
EBM
EBM
EBM Battery
Connectors
Figure 10. Typical Installation (120V UPS Model Shown)
INSTALLATION
Power Cord Output Receptacles
® S
Applications 164201633 Rev A
7