Starting / Stopping The Engine - Solo 467 Manual De Instrucciones

Starting / Stopping the engine

6. Starting / Stopping the engine
Starting with cold engine
Fig. 4
 Switch On/Off Switch (1) to "I" position.
Fig. 5
 Close choke with choke lever (5).
 Press primer (4) several times until fuel is visible
in the primer.
 Hold the machine with your left hand on the
carrying handle (15). With the right hand, slowly
pull out the starter handle (8) until resistance is
felt. Then pull quickly and forcibly until the
engine attempts to start (engine fires).
 Once the engine tries to start, immediately open
the choke and continue to start.
ENGLISH 8
 When the engine runs, use the throttle lever (2)
to accelerate to the required engine speed.
 To return to idling speed, release the throttle
lever.
Starting with warm engine after short stop
 Leave choke in "open" position
engine.
Should the engine refuse to start despite several
starting attempts, the combustion chamber is most
likely flooded.
In this case we recommend you remove and dry
the spark plug (9). Set the ignition switch to "0".
Pull over engine several times, still with spark plug
removed. This will ventilate the combustion
chamber
Replace spark plug and repeat starting procedure.
Shutting off engine
 Release throttle lever and move throttle lock
lever to "min" position.
 Move ignition switch to "0" position until engine
stops.
and start