Festo SPC200 Manual Del Usario página 19

4 Instructions on commissioning
You can set the field bus address of the SPC200 with the
WinPISA software package or with the control panel. The
size of the I/O address range to be configured depends on
the operating mode and on the additional functions used
(parameter channel and transmission of the actual posi
tions) (see manual P.BE−SPC200−COM−PDP...).
Function
I/O signals
(I10 0 I13 15 (I10.0...I13.15,
Q10.0...Q13.15)
Parameter channel
(optional)
Actual positions
(optional)
1)
Freely programmable I/Os are only available in the operating mode
Start/Stop.
2)
For this function you require a field bus module with firmware
version as from V 2.0, an SPC200 with operating system version as
from V 4.6 and WinPISA as from version 4.3.
Festo SPC200−COM−PDP 0302a English
Address range
required
Start/Stop mode
2, 4, 6 or 8 I−bytes
2, 4, 6 or 8 O−bytes
Record Select mode
2 I−bytes
4 O−bytes
2)
4 I−words
4 O−words
2)
2 I−words per axis
Consistency of
1)
1 I−byte or complete
length
1 O−byte or complete
length
Complete length
Complete length
Complete length
Complete length
19