Festo SPC200 Manual Del Usario página 16

Fitting modules
1. Switch off the compressed air supply and the operat
ing voltage supply.
2. If necessary, unlock the retaining lever and remove the
blanking plate.
3. Hold the module by the front plate and push it into the
guide rail. Make sure that the modules are not tilted
when they are pushed in and that no components on
the printed circuit board are damaged.
4. Make sure that the plugs of the terminal strips are cor
rectly aligned. Then gently push the module in as far
as possible. The retaining levers will then lock auto
matically (see diagram).
16 Festo SPC200−COM−PDP 0302a English