Installing The Telephone - Alcatel Temporis 10 Manual Del Usuario

Temporis_10.qxp 14/11/2008
1.

INSTALLING THE TELEPHONE

Your Temporis 10 telephone comprises:
a base and a handset,
a telephone cord,
an emergency numbers label.
Connect one end of the telephone cord (spiral part) to the jack on the bottom
of the handset. Connect the other end of the line cord to the wall telephone
jack.
2. WALL MOUNTING THE TELEPHONE
To install the telephone on the wall, run the line cord
(straight part) through the 2 slots under the base
(bottom).
Drill two vertical holes in the wall, 83 mm apart.
Insert the anchors then screw in wood screws
(diameter: 3 mm, length: 25 mm) without tightening
them. Secure the base to the screws pulling it
downwards.
On the base, pivot the round plastic part (with a flat
screwdriver or small coin) so that the word "wall"
can be read correctly.
!
The screws are not supplied in the package.
3. USING THE TEMPORIS 10
Calling a correspondent
Pick up the handset, wait for the tone and dial the number of the person
you want to talk to.
Redialling the last number
Pick up the handset to obtain a tone then press the
Adjusting the ringing volume (2 levels) on the handset top side
The ringing volume adjustment is by default set to the highest volume
( ). You can reduce it by placing the cursor opposite ( ).
13:56 Page 39
Plastic part
key.
39