Installing The Telephone - Alcatel Temporis 06 Manual Del Usuario

Temporis_06.qxd
1.
Your Temporis 06 telephone comprises:
l
l
l
l
1. Connect one end of the spiral cord to the handset and the other to the
2. Place the ringer cursor under the base to the maximum (
2.
To install the telephone on the wall, extract the tab (small serrated plastic
part) from its housing under the base and reinsert it upside down.
Run the line cord through the smaller slot under the base.
Drill two vertical holes in the wall, 85 mm apart. Insert the anchors then
screw in wood screws (diameter: 3 mm, length: 30 mm) without
tightening them. Secure the base to the screws.
3.
l
l
l
D i t d o c u me n t wo r d t u a a n g e b o d e n d o o r T e l e c o mH u n t e r . D é z a k e l i j k e T e l e c o m we b s h o p .
T 0 8 8 7 4 6 3 4 4 4 | @ s a l e s @T e l e c o mH u n t e r . n l | www. T e l e c o mH u n t e r . n l
22/11/02 09:07

INSTALLING THE TELEPHONE

a base and a handset,
a telephone cord,
a spiral cord,
an emergency numbers label.
lower part of the base.
Connect the line cord to its socket in the cavity under the base then
run the wire through the longer slot (unless you want to wall mount it,
see § 2: "Wall mounting the telephone"). Connect the other end of the
line cord to the wall telephone jack.
( ) volume.
WALL MOUNTING THE TELEPHONE
USING THE TEMPORIS 06
Calling a correspondent
Pick up the handset, wait for the tone and dial the number of the person
you want to talk to.
Redialling the last number
Pick up the handset to obtain a tone then press the
Adjusting the ringing volume (3 levels)
The ringing volume adjustment is located under the telephone base and
is by default set to the highest volume (
the cursor opposite ( ) or temporarily cut off the ringer (
Page 31
) or minimum
key.
). You can reduce it by placing
).
31