Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DIGITAL POSITION INDICATOR (DITRON DL50 SERIES)
After having made the settings, press
to save and exit, then press
to enter the DRO
mode setting.
25.4.6 DRO mode setting
Mode setting way will be as follows:
Mill Mode
Lathe Mode
Once you have set the DRO mode, press
to save and exit, and then press
to enter the
axis number setting.
25.4.7 Axis Number Setting
Users may turn on or off 1 or 2 of the axis. The setting way will be as follows:
This function is unavailable for single axis DRO.
After having set press
to save and exit, then press
to check the ID of the DRO.
25.4.8 Checking the ID of the DRO
Every set of DL50 has ist own ID. The ID consists of 24 digits. To check the ID proceed as shown
in the below illustration:
When the DRO is single axis, the ID will be displayed on the X axis. It will be displayed on Y axis
for 2 axis DROs which need to press
to check the complete ID. Press
to get back. It will
be displayed on X, Y and Z axis for 3 axis DROs. After having checked the ID press
to exit the
system menu.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
66
ED400FD | ED400FDDIG
Publicidad
Tabla de contenido
