Turning Short Taper With The Top Slide; Thread Cutting; Cleaning; Maintenance - Holzmann ED400FD Instrucciones De Servicio

19.5.6 Turning Short Taper with the Top Slide

19.5.7 Thread Cutting

Threading or tapping requires good turning skills and sufficient experience from the operator.
 The engagement lever for thread cutting must remain closed during the entire thread
cutting process. Excluded are the thread pitches which can be carried out with the tapping
watch.
 The thread is produced in several cutting operations, so that the turning tool must be
completely turned out of the thread (with the facing slide) at the end of a cutting
operation.
 The return path is made with the clasp nut closed and the thread turning tool not engaged
by actuating the "Shift lever Direction of rotation".
 Switch off the lathe and reposition the chisel in small cutting depths with the cross slide.
 Before each run, adjust the upper slide by approx. 0.2 to 0.3 mm alternately to the left
and right in order to free the thread. The thread chisel therefore only cuts on one thread
flank in each pass. Do not cut free until shortly before reaching the full thread depth.
20

CLEANING

Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Therefore, clean the device after each use of chips and dirt particles.
21

MAINTENANCE

Danger due to electrical voltage! Handling the machine with the power supply up
may result in serious injury or death. Always disconnect the machine from the power
supply before servicing or maintenance work and secure it against unintentional
restart!
HOLZMANN MASCHINEN GmbH
The short taper is turned by hand with the top slide. The
upper slide is swivelled according to the desired angle. The
infeed takes place with the cross slide:
1. Loosen the two clamping screws at the front and rear of
the upper slide.
2. Turn the upper slide to the desired position.
3. Clamp the upper slide again.
Example Outside Thread:
 The workpiece diameter must be turned to the diameter of
the desired thread.
 The workpiece requires a chamfer at the beginning of the
thread and an undercut at the end of the thread.
 The speed must be as low as possible.
 The thread chisel must correspond exactly to the thread
form, be absolutely right-angled and clamped exactly to the
turning centre.
NOTICE
WARNING
www.holzmann-maschinen.at
CLEANING
58
ED400FD | ED400FDDIG