Troubleshooting - Beem MD-258BT Manual De Instrucciones

27
Storage
Disconnect the device from the mains power when it is not going to be used for a prolonged
period. Clean the device again if necessary (see the "Cleaning and Care" chapter) and let it dry
completely.
Store the device and all accessories in a dry, clean, frost-free place that is protected from direct
sunlight and cannot be accessed by children or animals.

Troubleshooting

If the device does not work properly, check whether you are able to rectify a problem yourself. If
the problem cannot be solved with the steps that are listed, contact our customer service depart-
ment.
Do not attempt to repair an electrical device yourself!
Problem
Nothing is shown on
the display (3).
The fuse in the fuse box
is triggered.
The brewing process is
not started.
Water runs out of the
device.
02442_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 27 02442_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 27
Possible cause
The mains plug is not inserted
correctly in the plug socket.
The plug socket is defective.
There is no mains voltage.
Too many devices connected to
the same circuit.
There is no / too little water in
the water tank (10).
There is too much water in the
water tank (10).
The thermal jug (6) was removed
from the device during the
brewing process and as a result
there is too much water in the
permanent fi lter (8).
The coffee powder used is too
fi nely ground and the water
is unable to pass through the
permanent fi lter (8).
Fix
Correct the fi t of the mains plug.
Try another plug socket.
Check the fuse of the mains
connection.
Reduce the number of devices in
the circuit.
Fill the water tank at least up to
the 4 cups mark.
Do not overfi ll the water tank!
During the brewing process,
remove the thermal jug from
the device for no more than 30
seconds.
Use coffee powder with a
coarser grind.
06.12.2019 11:35:02 06.12.2019 11:35:02
EN