Campbell Hausfeld 3/4 HP UNITS Instrucciones De Funcionamiento Y Montaje página 4

Operating Instructions and Assembly Instructions
Airless Painting Systems
General Safety Information
(Continued)
spirits, lacquer thinner, Xylene and
high flash naphtha. A partial example
list of unacceptable cleaning solvents
are low flash naphtha, mek, acetone,
alcohol and toluene).
Do not spray
WARNING
!
flam-
mable materials in vicinity
of open flame or near
ignition sources. Motors,
electrical equipment and
controls can cause electrical arcs that
will ignite a flammable gas or vapor.
Never store flammable liquids or gases
in the vicinity of the unit.
Do not spray acids,
WARNING
!
corrosive materials,
toxic chemicals, fertilizers or
pesticides. Using these materials could
result in death or serious injury.
G Do not use fuels to clean this
equipment.
G Keep spraying area well ventilated.
Keep doors and windows open.
G Remove all ignition sources (i.e.
Static electricity, pilot lights,
cigarettes and electrical arcing).
G Airless spraying can cause static
electricity. Always ground the
pump and spraying surface. Always
use a 3-wire grounded extension
cord and power receptacle.
G Do not use solvents containing
halogenated hydrocarbons.
Keep hose away
CAUTION
!
from sharp objects.
Bursting hoses may cause injury.
Examine hoses regularly and replace if
damaged.
G Check hoses for weak or worn
condition before each use, making
certain that all connections are
secure.
FAILURE TO FOLLOW
THESE INSTRUCTIONS
CAN RESULT IN SERIOUS
INJURY OR DEATH.
www.chpower.com
Assembly Instructions
One Gun Assembly
Two Gun Assembly
Applies only to 1 HP paint sprayers
Second Gun and Hose Not Included
Plug Removal*
*
Replace plug with second
hose adapter (included with
sprayer). Copper seal washer
must remain in place.
4
A