Assembling/Dismantling The Two-Piece Suction Tube; Installing/Removing The Collection Bag - Parkside PLS 3000 A1 Traducción Del Manual De Instrucciones Original

GB MT
2. Now push the blower pipe (9) on to
the blowing aperture of the motor
housing (1) until the locking knob (8)
latches into place.
3. The protective cover of the suction
aperture (7) must be closed.
Close the protective cover and tighten
it using the screw and star grip (13).
The screw with star grip has to be
tightened as far as it will go by
hand, as otherwise the leaf blower
cannot be started later.
4. Remove the blower pipe (9) by loose-
ning the locking knob (8) and pulling
the blower pipe forwards.
Assembling/dismantling
the two-piece suction
tube
Never use the leaf vacuum
with only one suction tube
section attached. There is a
risk of personal injury!
After the two-part suction
tube has been assembled, it
must not be divided up again
into two parts!
1. Open the protective cover (7) of the
suction aperture by first unscrewing the
screw and star grip (13) and folding
open the protective cover (7).
2. Assemble the two suction tubes (16) as
illustrated. The parts can be felt to lock
into place.
When putting it together, make sure
that the symbols (
lower suction pipe interlock.
3. First suspend the suction tube (16) onto
the hook on the lower side of the motor
76
) at the upper and
housing (1) using the connector (see de-
tailed illustration). Then attach the suc-
tion tube (16) to the suction aperture.
4. Attach the suction tube by screwing it
into the motor housing (1) using the star
grip and screw (17).
The screw with star grip has to be
tightened as far as it will go by
hand, as otherwise the leaf vacuum
cannot be started later.
5. Remove the suction tube (16) by relea-
sing the screw and star grip (17) and
unhooking the suction tube.
Installing/removing the
collection bag
In suction mode the device can only
be operated with the collection bag
installed.
The ventilation opening on the collection
bag ( 20) serves for an improved air
C
circulation.
1. If necessary, remove the blower tube (
9) (see „Assembling/dismantling the
A
two-piece blow tube").
2. Now push the collection bag (14) on to
the blowing aperture of the motor hou-
sing (1) until it latches with the locking
knob (8).
3. Hang the carabiner (15) of the collec-
tion bag (14) on the eyelets (19) provi-
ded on the suction tube.
The additional handle (10) can be locked
in various positions. In order to change
the handle position, release the screw with
star grip (18), change the handle position
and tighten the screw again.