Putting On The Carrying Strap; Operating The Leaf Blower; Turning On And Off; Working With The Leaf Blower - Parkside PLS 3000 A1 Traducción Del Manual De Instrucciones Original

Putting on the carrying
C
strap
Never wear the carrying
strap diagonally across your
shoulders and chest: only
wear it on one shoulder to
ensure you can detach the
device quickly from your
body in the event of danger.
Pulling the push-fit lock (21) relea-
ses the device quickly from the
carrying strap. To open the push-fit
lock, press the two clamps together.
1. Place the carrying strap (12) on one
shoulder.
2. Adjust the length of the strap so that
the snap hook is approximately 10 cm
below your hip.
3. Attach the snap hook on the eyelet to
insert the strap:
- in blow mode: position 11b.
- in suction mode: position 11a.

Operating the leaf blower

Danger of injury. Wear suita-
ble clothing and work gloves
when working with the
device. Make sure that the
device is functioning prop-
erly before every use. Make
sure that the collection bag
and the tube are assembled
correctly and the carrying
strap is adjusted correctly for
work.
Stop using the device if the
on/of switch is damaged.
Personal protective equip-
ment and a fully functional
appliance reduce the risk of
injuries and accidents.
After switching off the de-
vice, the impeller wheel
continues to rotate for some
time. Danger of injury due to
rotating tool.
Note noise protection laws and lo-
cal regulations.
D

Turning on and off

Before switching on device, make
sure it is not in contact with any ob-
jects. Ensure stable positioning.
1. Make a loop from the end of the exten-
sion cable and attach this to the strain
relief (5).
2. Connect the machine to the power sup-
ply.
3. To turn on, push the on/off switch (4):
- in blow mode: to the right.
- in suction mode: to the left.
4. In order to regulate the suction/
blowing power, press the volume con-
trol (3).
5. To turn off, push the on/off switch (4):
- in blow mode: to the left.
- in suction mode: to the right.

Working with the leaf blower

The leaf vacuum/blower may
only be used for the follow-
ing purposes:
- As a blower to pile up dry
leaf material or to blow mate-
rial out of places that are hard
to access (e.g. under cars)
- As a suction device to suck
up dry leaf material. The
GB MT
77