Parkside PLS 3000 A1 Traducción Del Manual De Instrucciones Original página 71

damaged or worn out cable.
• Before each use, check the
power supply lead and the ex-
tension cable for damage and
ageing. Do not use the equip-
ment if the cable is damaged
or worn. Avoid bodily contact
with grounded parts (e.g. metal
fences, metal post).
• If a cable is damaged during
use, the mains connection ca-
ble must be disconnected from
the mains supply immediately.
DO NOT TOUCH THE CABLE
WHILE IT IS STILL CONNECTED
TO THE MAINS. Do not use the
machine if the cable is dam-
aged or worn.
• The coupling of the extension
cord must be protected against
splashed water, it must consist
of rubber or be surrounded by
rubber. Employ only extension
cords which are stipulated for
use in the open air and are
marked accordingly. The flex-
ible lead cross-section of the
extension cord must at least
2.5 mm 2 . The extension cable
must not be longer than 75 m.
Always roll out the cable drum
completely before use. Check
the cable for damage.
• Please be aware that the opera-
tor or user is responsible for
accidents or injuries to other
people or their property.
• Avoid wearing loose clothing,
clothing with hanging laces or
ties.
• Operate the machine in a rec-
ommended position and only
when standing on a solid, flat
surface.
• Do not operate the machine on
a paved surface or a gravel sur-
face where the ejected material
could cause injury.
• Always perform a visual inspec-
tion prior to use to make sure
that the shredding unit (includ-
ing its bolts) and other fastening
equipment are secured, as well
as that the housing is undam-
aged and the protective equip-
ment and shields are present.
Replace worn or damaged
components in sets to ensure
balance. Replace damaged or
illegible markings.
Operation:
• Do not allow other persons to
touch the device or the extension
cord. Keep the device away
from persons, particularly chil-
dren and domestic animals.
• Do not turn on the device if it is
upside down or is not in work-
ing position.
• Avoid starting accidentally. Ensure
that the device is switched off
before connecting to the power
supply, picking up, or carrying.
If you have a finger on the switch
whilst carrying the device or con-
nect the device to the power sup-
ply whilst it is switched on, this
may cause accidents.
• Do not point the device when it
is working at persons, in particu-
lar, do not point the airstream at
eyes and ears.
• While working, make sure that
you are standing in a firm posi-
tion – especially when you are
on a slope. Always hold the de-
GB MT
71