Safety Notes; General Notes; Function - Trix 290 V90 Serie Manual De Instrucciones

Safety Notes

• This locomotive is to be used only with an operating
system designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Do not expose the model to direct sunlight, extreme chan-
ges in temperature, or high humidity.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive
is to be run in conventional operation. The 611 655 inter-
ference suppression set is to be used for this purpose.
The interference suppression set is not suitable for digital
operation.

General Notes

• The operating instructions and the packaging are a compo-
nent part of the product and must therefore be kept as well
as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or spare
parts.
• http://www.maerklin.com/en/imprint.html
8
Functions
• Built-in electronic circuit for operation with a conventional
DC power pack (max. ±12 volts), Trix Systems,
Trix Selectrix or NMRA DCC digital systems.
• Automatic system recognition between digital and analog
operation.
• No automatic system recognition between Selectrix (SX)
and DCC.
• The full range of functions is only available under
Trix Systems and under DCC.
• Built-in headlights that change over with the direction of
travel. They can be turned on and off in digital operation.
• Minimum radius for operation is 420 mm / 16-9/16".
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.