Notes On Digital Operation; Controllable Functions - Trix 290 V90 Serie Manual De Instrucciones

Notes on digital operation

• The first time the locomotive is used in a digital system
(Selectrix or DCC), the decoder must be set for this digital
system. To do this, the decoder must be programmed once
in this digital system (Example: changing an address).
• The operating instructions for your central unit will give
you exact procedures for setting the different parameters.
• The values set at the factory were selected to guarantee
the best possible running characteristics.
• This locomotive comes from the factory programmed for
the digital address "01" (Selectrix) / "03" (DCC) Number of
speed levels that have been set: 28 (DCC) and 31 (Selectrix).

Controllable Functions

Headlights
Front Telex coupler
Rear Telex coupler
ABV
• The setting done at the factory does not permit operation
with opposite polarity DC power in the braking block. If
you want this characteristic, you must do without conven-
tional DC power operation (CV 29 / Bit 2 = 0).
• After the uncoupling procedure is completed, this
function must also be deactivated with the button on the
locomotive controller.
• Malfunctions resulting from changes to the factory
settings of the locomotive electronics are caused by the
operator and do not give grounds for complaint under our
guarantee or warranty obligations.
Central- Control
66800
1 2 3 4 5
6 7 8 9 ON
ST OP
PR Sx 1/2 Lz
on Headlight button
— —
— —
— —
�� ��
1
5
S T O P
mobile station
Function 1
Function 2
Function 4
�� ��
Function f0
Function f1
Function f2
Function f4
9