Sauder Office Port Hutch 408292 Manual Del Usuario página 13

Step 9
Fasten six METAL BRACKETS (W) to the ENDS (A and B).
å
Use six BLACK 9/16" LARGE HEAD SCREWS (GG).
NOTE: Be sure the BRACKETS are even with the edges of
å
the ENDS.
Fasten the END MOLDINGS (Q) to the ENDS (A and B).
å
Use four BLACK 9/16" LARGE HEAD SCREWS (GG).
NOTE: There are no pre-drilled holes in the END
å
MOLDINGS. The SCREWS will tighten into the grooves.
W
www.sauder.com/services
Q
B
(6 used)
BLACK 9/16" LARGE HEAD SCREW
(10 used in this step)
These METAL BRACKETS will fasten
to the END MOLDINGS in Step 12.
Q
W
408292
GG
A
Page 13