Sauder Office Port Hutch 408292 Manual Del Usuario página 17

Step 13
Unfold the BACK (J) and lay it over your unit.
å
Make equal margins along the top edge and both side
å
edges of the BACK (J). Push on opposite corners of your
unit if needed to make it "square".
Fasten the BACK (J) to your unit using the NAILS (II).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the SHELVES (H and I).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
These holes must line up
over the SHELVES (H and I).
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(54 used in this step)
J
Do not tap NAILS along the
bottom edge of the BACK.
Notch
408292
II
NAIL
Page 17