Sauder Office Port Hutch 408292 Manual Del Usuario página 16

Step 12
Carefully turn your unit over onto its front edges.
å
Fasten the remaining METAL BRACKETS on the ENDS (A
å
and B) to the END MOLDINGS (Q). Use two BLACK 9/16"
LARGE HEAD SCREWS (GG).
Push the RUBBER SLEEVES (DD) over the remaining
å
METAL PINS (CC). Insert the METAL PINS into the hole
locations of your choice in the ENDS (A and B) and
UPRIGHTS (C and D). Set the GLASS SHELVES (M) onto
the METAL PINS.
NOTE: The GLASS SHELVES (M) must be inserted at
å
this time. They cannot be inserted through the front of
the unit.
A
Q
BLACK 9/16" LARGE HEAD SCREW
(2 used in this step)
Page 16
C
M
CC
(8 used)
DD
GG
408292
Caution
Tempered safety glass is used. It is stronger
than normal glass, and it will not break into long,
sharp, knife-like shards. However, safety glass
can break. When safety glass breaks, it instantly
fractures into small, bead-like pieces. These
small pieces may have sharp edges.
For your safety, follow these precautions when
you assemble your product:
• Wear safety glasses or other eye protection.
• Do not try to drill into or cut safety glass. It
will instantly break into small pieces.
• Do not force the glass into position.
• If the glass breaks, be careful when you pick
up the pieces. They may have sharp edges.
D
M
Q
B
www.sauder.com/services