Sauder Office Port Hutch 408292 Manual Del Usuario página 14

Step 10
First, separate the Clamps from both Lights in the LIGHT SET (R)
å
by loosening the Screws in the Clamps.
Insert the cords of both Lights of the LIGHT SET (R) up through
å
the bottom surface of the TOP (G2).
Slip a Clamp over both Lights and fasten them to the TOP (G2).
å
Use two BLACK 9/16" LARGE HEAD SCREWS (GG). Then,
tighten the Screws on the Clamps.
Remove the nut and washer from the Switch and insert the
å
Switch into the hole in the TOP (G2). Turn the nut and washer
onto the Switch and tighten the nut by hand. Then, use your
pliers to make snug.
Plug the cords into one another. Do not plug the cord into an
å
outlet until assembly is complete and you have moved the unit to
its fi nal destination.
Insert the LIGHTS up
through the TOP (G2).
Switch
Light with one cord
Page 14
G2
Clamp
Light with two cords
Clamp
408292
Washer
Switch
BLACK 9/16" LARGE HEAD SCREW
(2 used in this step)
www.sauder.com/services
Nut
GG