Group Configuration; Import - Optimus NOVA-500 Manual De Instalación Y Funcionamiento

-
Neighboring mode:
This mode is used for Emergency functions, and it permits to broadcast ALERT and EVAC
messages sequentially to different zones. EVAC message will be broadcasted by the zone
corresponding to input contact (Ex: contact 3 makes evac message to be broadcasted by
zone 3) and ALERT message will be broadcasted by previous and next zones according to ‐
(0~4) and +(0~4) numbers. (Ex: ‐(0~4) set to 2 and +(0~4) set to 1, contact input 3 activates
EVAC message to zone 3 and ALERT message to zone 1, 2 and 4.). In this mode you can also
select the play method, you can select message repetitions with Specifies the number of
playback and Number of playback (1~100) or the time with Specifies the time to play and
Play time (5‐300s).
5.3.7. Group configuration
This menu is used to create zone groups.
There are 120 groups available which can be configured with different zones of the system. These
groups are only used to operate the system from the Software State and Control menu.
5.3.8. Import
This menu is used to Import system configuration.
The file to import must be exported from the software or extracted from the memory card. It is a
*.cfg file. Press , select the file location and press Open, the file will be automatically loaded in
the system.
Note: only configuration file is imported, audio messages are not included.
NOVA Version 1.0
NOVA
Voice Evacuation System
Page 23 of 34