Operation From State And Control; Upgrade Nova-500 Firmware - Optimus NOVA-500 Manual De Instalación Y Funcionamiento

5.7.7. Operation from State and Control
-
Broadcast ALERT or EVAC messages: Press Emergency button in NOVA‐500 front panel.
Select a group of zones and then press ALERT or EVAC buttons. ALERT and EVAC messages
do not work with individual zone selection.
-
Broadcast BGM internal messages: Select Host 1 and the message, then a group of zones
and finally press BGM. BGM messages do not work with individual zone selection.
-
Broadcast INPUT 1‐6 audio: Select Host (NOVA‐500/NOVA‐500S) and input, then select
zones or groups. Using zones, you can select independently different audio inputs for
NOVA‐500 and NOVA‐500S. Using groups, the input of the NOVA‐500 is broadcasted to
NOVA‐500 and NOVA‐500S.
-
Stop BGM messages or disable Line inputs: Select zone/groups or All icon and then press
over Off icon from Control panel.
-
Stop ALERT or EVAC messages: These messages can only be stopped by finish Emergency
mode pressing again Emergency button in NOVA‐500 front panel or closing EMERGENCY
RESET contact.
5.8. UPGRADE NOVA‐500 FIRMWARE
In the main menu select Tool(T)
Press over the firmware Icon, file explorer will open, and select the location of the firmware file
(*.bin). Then select the Host unit to update add then press >>. Finally press the bottom button to
start firmware update.
IMPORTANT NOTE: Do not power off the unit during firmware update as it may result in an
irrecoverable state.
NOVA Version 1.0
NOVA

Upgrade firmware and following menu will appear.
Voice Evacuation System
Page 31 of 34