Cleaning And Maintenance; General Advice; Outer Surfaces - Proline CB23SS Manual De Instrucciones

CLEANING AND MAINTENANCE

Before any cleaning or maintenance operation, disconnect the microwave
oven from the mains supply and allow it to cool to room temperature.

General Advice

Frequent cleaning prevents the formation of smoke and bad odours during cooking and
also sparking in the oven cavity and around the door seal.
Do not let food deposits or grease accumulate inside the oven cavity or on the door
seal.
Make sure that the waveguide cover is kept clean at all times. Should food deposits or
grease be allowed to accumulate on the cover, sparking will occur and may damage
your oven invalidating the warranty.
Oven Door
Remove any food deposits and grease between the door seal and oven cavity using a
damp cloth, it is important to keep this area clean at all times.
Interior Walls
Remove any grease splashes from the oven cavity walls with soap and water, then rinse
and dry.
The door seal and oven cavity have to be particularly well cleaned to ensure the door
will close properly and to avoid sparking between the oven cavity and door assembly.
Do not use abrasive products such as scouring pads which will damage the surfaces of
the oven cavity and door.

Outer Surfaces

To clean the outside surface, use a damp cloth.
Avoid using abrasive products such as scouring pads that may damage the cosmetic
surfaces. Make sure water does not seep into the ventilation slots.
Accessories should be washed in warm soapy water by hand.
12